返回列表 回復 發帖

billige beats by dre solo hd monster beats by dr dre cheap sale outlet cheapest

ch_client = "articlealley";
ch_width = 675;
ch_height = 200;
ch_sid = "Article Alley Articles North MPU";
ch_cid = "north";
ch_type = "mpu";
ch_hq = 1;
??
When you're taping sheetrock seams, it's imperative that you apply an even coat of drywall mud for a smooth finish. Fiberglass mesh is easier to use than drywall paper tape and it resists bubbling. Although paper tape is quicker if you're a professional, most do-it-yourselfers will find that fiberglass mesh offers a workable substitute.
Step1
Prepare your installed drywall sheets by aligning the edges as tightly as possible before beginning the taping process. Wipe the bare seams down with a tack cloth to remove drywall dust.
Step2
Unroll  over the ear beats by dre one end of the fiberglass mesh and determine which side is sticky. Begin at the top and stick only the top edge of the mesh on the seam. Leave a 1-inch space from the ceiling. Carefully, unroll the mesh as you hold it outwards from the wall. If you allow it to touch too soon,  beats by dre over ear it will adhere and make it difficult to apply in a straight line.
Step3
Hold  dr dre in ear beats the bottom edge of the unrolled fiberglass mesh at the bottom of the seam. While watching to make sure the seam is  over ear beats in the middle of the mesh, lower it until it  casque beats by dr dre meets the wall.
Step4
Cut the bottom edge of the mesh and use your hands to gently smooth the mesh from the center to each end, ensuring that no wrinkles form.
Step5
Scoop some prepared drywall mud into a taping bucket with the 6-inch taping knife. Using the same knife, pick up a small portion of the mud, approximately one-half cup, and put it on the fiberglass mesh, smoothing as you go. Since this is the first coat, use some pressure to force the mud through the holes in the mesh and into the seam. Cover the entire seam with an even coat of mud.
Step6
Follow up immediately, while the mud is still soft, with the 10-inch taping trowel. Pull the trowel along the seam carefully, smoothing the mud and leveling it with the surface of the wall. Make sure you smooth out any crown on the seam.
ch_client = "articlealley";
ch_width = 675;
ch_height = 200;
ch_sid = "Article Alley Articles North MPU";
ch_cid = "north";
ch_type = "mpu";
ch_hq = 1;
Step7
Allow the mud to dry, sand off rough edges or lumps and apply two more very thin coats. Sand after the last coat is dry and paint or texture your walls.
??
Warnings
???・????If you get a wrinkle in the mesh when you're applying it to the seams, use the utility knife to cut out the wrinkle as closely as possible and proceed to tape the seam.
?・????Fiberglass mesh is easier to use  casque audio beats than taper's paper, but it is thicker and requires more mud to cover.
??
Related articles:

  
   beats by dre kopen monster beats by dr dre cheap sale outlet cheapest sale (1)
返回列表